Search For Parts
Search
 

Course Objective

The Operator course is designed for Operators, Supervisors and Technicians involved in the Operation of gas turbines with the subject Turbine Control Panel (TCP). One of the fundamental objectives of the course is to teach the basic knowledge to identify and determine the cause of process and diagnostic alarms in the TCP. During the course, we will also discuss gas turbine fundamentals, main auxiliary systems, introduction to: gas turbine protection, TCP hardware, etc.
The course provides the fundamental tools to operate the Gas Turbine utilizing the TCP, and an introduction to theoretical aspects to further the self-learning process.


Course Outline

Duration: 5 Days

Day 1
  • Gas Turbine and its Components – Fundamentals
    • Gas Turbine basic theory
    • Frame and Supports
    • Air Inlet and Exhaust
    • Axial Compressor
    • Combustion
    • Turbine
    • Bearings
    • Fuel Valves
    • Control Fundamentals
  • Introduction to Gas Turbine Operation
    • Main Screen
    • Other Screens – Navigation
Day 2
  • Mark VIe Hardware
    • UCSx Controller
    • I/O Packs
      • Digital I/O
      • Thermocouples
      • RTDs
      • Analog I/O
      • Dedicated I/O
    • Terminal Boards
  • Mark VIe Hardware Exercise
  • Mark VIe Documentation
    • Device Summary
    • I/O Report
    • Control Logic
    • Process Alarm List
    • Layout
    • Interconnection Diagram
Day 3
  • ToolboxST – Introduction
  • ToolboxST – Hardware Management
  • Finder, Logic Forcing, Control Constants
  • Control Software Structure
  • Blockware (Control Blocks Library)
  • MarkVIe Alarms
    • Drop Numbers
    • Process Alarms
    • Diagnostic Alarms
  • WorkstationST Alarm Viewer – Alarm management
    • Silence, Acknowledge, Reset, Block
    • Sequence of Events (SOE)
  • Trip Log
  • Gas Turbine Operation
    • Cooldown Sequence
    • Start-Up Permissives, Trips, Emergency Trip – Ready to Start
    • Start-Up and Shutdown Sequence
    • Operating Modes: Crank, Fire, Auto, Remote. Pre-Selected Load, Base Load, Synchronization. Failure to Synchronize
    • Peak Load, Fast Start
Day 4
  • Auxiliary Systems(1) and Control Logic in MarkVIe.
    • Lube Oil
    • Air Inlet and Exhaust
    • Cooling and Sealing Air
    • Hydraulic Supply
    • Trip Oil
    • Compressor Water Wash
  • Gas Turbine Operation
    • Speed and Temperature Control
    • Droop/Isochronous Control
    • IGV Control
    • Manual FSR

Note: Some systems may carry over to Day 5 depending on the completion achieved.

Day 5
  • Mark VIe Protection Systems
    • Trip Solenoids
    • I/O Packs PPRO y PTUR philosophy
  • Final Exam

 

(1) For each System we will discuss:

  • Description
  • Piping Schematic flow
  • Main Components
  • Control Sequence, System Alarms
  • MCC Description – if applicable